Tusk Crank Puller/Installer Tool C-clip Adaptor

Customer Reviews for Tusk Crank Puller/Installer Tool C-clip Adaptor

Overall customer review score:

Showing All 3 Reviews

Return to Tusk Crank Puller/Installer Tool C-clip Adaptor Product Page

Reviews by real power sport enthusiasts...your opinion counts to us and fellow riders! Make the best purchasing decision by getting the latest reviews.

Customer Reviews

Tusk Crank Puller/Installer Tool C-clip Adaptor Reviews

Your review could win you a $100 or $500 gift card!

Each review submitted enters you into a $100 gift card monthly drawing, and a $500 gift card quarterly drawing!

Write a review on this productWrite reviews on past items you've purchased
0 of 0 people found this review helpful.

Works but not durable

Joshua in NB – Machine this part was bought for: 2004 KAWASAKI KX250

Comments On May 21, 2013:I used this to pull a 2004 KX250 crank into the crank case and it worked however the c clip bent slightly from the force and was very hard to get off the crank, I had to use the tusk puller to pull the clip off as it would not fit back out past the threads on the puller cap.
I usually use the Cold crank, hot bearing trick however this puller is used for pulling the crank into the second half of the case and centering it if needed.

Was this review helpful?

0 of 0 people found this review helpful.

Must have tool

Neal in ON

Comments On Feb 24, 2013:worked great very happy

Was this review helpful?

0 of 0 people found this review helpful.

2004 KX250

Larry in TX

Comments On May 18, 2011:Nice addition to the crank puller tool. Wish I would have had this when I did the main bearings. Had to use the freezer/heat method to install the snap ring side into the case half. But I got that sucker for the next time I replace the mains!

Was this review helpful?