Please select make, model and yearHydraulic Clutches
Hydraulic clutches that makes clutch pull much easier.
Brett in UT
This is a nice mod to the bike. Lever actuation force went down about 30%, and the action is smooth and easy. Installation was tricky. The bike had an aftermarket clutch in it, and the stack height was slight different than the Yamaha OEM. This made it impossible to set the amount of pull play specified by Magura. Replaced the aftermarket clutch with the Yamaha OEM clutch, and everything lined up perfectly. The hydraulic tube is about 6 inches too long, and the slack causes the tube to arc up at the handlebars. Noticeable, but so far not a problem.Read All Reviews
MICHAEL in CA
this is my 2nd replacement cable. If you dump your bike and the bars fall into soft dirt it puts pressure on the line where is screws into the master cylinder, the cable snaps where it screws into the cylinder leaving you with no clutch since the fluid drains out as the cable is dangling. I have no choice put to continue to buy this line since no one else makes a repacement that has ends on the cable that is not made out of pot metal! If the ends on the cable were made out of steel, the line would possibly bend, not brake when it gets an impact. I am surprised that no one has posted this issue. I plan to call Magura and complain. None of my friends are willing to put this on their race bikes because of this issue. They laugh at me every time they see me pushing the bike off the track.Read All Reviews