Locks/Security from Rocky Mountain ATV/MC

Security products to help keep your machine safe and locked up.

Latest Dual Sport Locks/Security Reviews – You could win up to $500 for reviewing products!

  • Rider Cargo Motorcycle Fork Brace

    Rider Cargo Motorcycle Fork Brace

    Bob in BC

    Does the Job

    Works great and saves the extra pressure on the fork seals during transport while strapped down.

    Read All Reviews
  • SPS Motorcycle Bed Rack

    SPS Motorcycle Bed Rack

    Randal in TX

    Very Difficult Install on 2011 Ford F150 SuperCrew

    Overall, good quality and works as intended with optional 3rd bike setback bracket. However, there were no photos of rack installed in a truck anywhere that I could find so when I measured, I wasn't exactly sure where I needed to measure and ended up purchasing the 63" model which ended up being about 1/2" too long to fit in the Ford bed. I trimmed 1/4" off both ends at a machine shop. --------------------------------------------------------------------------------------------- Measure width about 1-1/2" below the top of the bed. That is about how far down I drilled the holes. The Ford measures about 62-7/8" at that spot. Given we haul a KX 85, it probably would have been better to have mounted the rack a little lower but this would have meant the fender washers would have to be bent to fit the contour of the bed. --------------------------------------------------------------------------------------------- Whether you have a Ford or something else, look at the space you've got to work with between cab and bed and plan how you're going to do the install before getting the rack. --------------------------------------------------------------------------------------------- The installation headache is due to the contoured design of the Ford cab and bed with very little clearance. No swiveling socket or offset wrenches I had could hold the nut in place. My solution was to tape the fender washers in place by feel, jamming my fingers into the tight space. I used very tacky RV roof repair tape to stick the nut to my finger and then threaded the nut onto the bolt by feel. I then managed to slide a thin box end wrench into the space and work it over to the nut by feel to hold the nut while tightening the bolts. --------------------------------------------------------------------------------------------- I give only 3 stars because I couldn't find a way to contact the manufacturer for installation advice nor could I locate a web site with any photos of anything other than the rack itself. There were no detailed instructions/photos included. The instructions were just a diagram of the obvious - you bolt the rack onto the bed using supplied bolts, nuts and fender washer. No guidance was provided about how far down from the top of the bed is the optimal install location.

    Read All Reviews
  • Universal Samson Bed Rack

    Universal Samson Bed Rack

    TODD in GA

    used it INSIDE my sprinter van

    works great! ,especially with (expensive) extender

    Read All Reviews
  • Universal Treo Rack Extender for Samson Bed Rack

    Universal Treo Rack Extender for Samson Bed Rack

    TODD in GA

    seems ok

    I am using it inside my (sprinter) van ...seems a little flimsy because it is aluminum.... works fine though

    Read All Reviews
  • PC Racing Fork Support

    PC Racing Fork Support

    DIMITRI in PA

    best support out there

    best fork support there is. Do not buy any other i just bought 2 more for my kids bikes and the one i have for my bike is over 10 years old. the short stile one is great for conventional forks and the large is great for inverted forks. i have run this support over with my truck and it is still good. like I said don't by any other brand!!!

    Read All Reviews
  • Risk Racing Lock-N-Load Moto Transport System

    Risk Racing Lock-N-Load Moto Transport System

    Robert L. in PA

    good product

    was looking for a easier way to tie down the bike in toy hauler only need 4 holes in the floor very happy with the way it holds the bike. my bike is a 250 2 stroke I just tilt it a little to get the bike in. load and unload in no time. works as advertised

    Read All Reviews
Frequent Buyer ProgramParts Finder