This is a "machine-selection optional" part.Please choose a vehicle to see products specific to your machine,select a product below.
User Tip: If you're unsure of your vehicle type, you may skip the machine type selection box.
UTV Side x Side Seats and Accessories that add comfort and styling to your UTV.

Riley in SK
After reading all the horror stories about flips with stock 3 point harnesses i decided on some beard 4 point harnessess, one of the best purchases that i have made for my atv, hold you in your seat nice and snug. would never have another utv without some kind of harness, and with the automotive belt buckle it works great for passangers unfirmiliar with the conventional harness latch. i would highly recommend this harness!
Read All Reviews
Phil in CO
Commentary: These are total overkill for a RZR. They are made of ~3" nylon, that I would have no qualms towing with. I'm guessing 18000lb break strength and 6000lb working load type stuff.. Installation: You have to remove the existing inertial seat belts to install them. Getting the reel out requires removing a side panel. Getting the buckle receiver out is a bit of a pain as there isn't alot of wrench room. The top of the harness just straps around the roll cage behind the seat. It's about a 45 minute job total. Pros: Once installed they are straightforward to get in and out of. . Properly adjusted you're not coming off the machine unless the machine comes apart. Cons: If you have folks of different sizes riding in it, the spring belt retainers are difficult to adjust. You'll need rear view mirrors to see what is behind you as it becomes next to impossible to turn around.
Read All Reviews
Douglas in NE
Seem to get in my way but work well for the ladies with tank tops on and the kids to protect their necks. Have sprayed the mud and dirt off without an issue.
Read All Reviews
John in TX
If you own a side by side you need these belts. 1000 times better and more comfortable than stock. They work easy.
Read All Reviews
paul in KS
Fits great and looks better!!
Read All Reviews
Audrey in ID
Simple installation. Took approximately 30 seconds on each side. One thing to mention. Although this is certainly an "look good on the machine item", it will serve as some protection in a hard impact/jolt where your head could snap back and crack into the stock seatbelt harness locations.
Read All Reviews