This is a "machine-selection optional" part.Please choose a vehicle to see products specific to your machine,select a product below.
User Tip: If you're unsure of your vehicle type, you may skip the machine type selection box.
Interior accessories that helps set your machine apart.
CARLOS in NM
I bought mine to match my yellow body plastic. It looks great but the top is starting to have a little gap and it made it so that the key was really tight and wouldn't spring back to run when you turned it to start. I trimmed the rubber on the key and it works like normal now.Read All Reviews
ROBERT in AZ
Hello I bought a set of these thinking that they would make sure drinks would not tople over in holders. However the aluminum drink holders have a "bottom" in them. thus only raising your drink up... There is a fix grind out the welds and remove bottoms... and PRESTO a really awsome product really deep using the bottom of the ORIG polaris drink holder. HOPE THE MANUFACTURER IS READING They have a good idea but needs refined, and it will save them moneyRead All Reviews
WALTER in MD
LOOKS GREAT WHEN YOU RECIEVE IT, NICE WORKMANSHIIP,BUT WHEN INSTALLED, IT WASN'T JUST RIGHT. I NEEDED TO MAKE THE SLOT BIGGER SO IT WOULD PINCH TIGHTER, THEN I NEEDED TO PUT A BIGGER TWIST NUT ON IT SO IT COULD BE ADJUSTED EASY.Read All Reviews
Phil in CO
I'm not sure what I was expecting. These appear to be watercut, good qualsity aluminum diamond plate. They are well cut and fit great in my 2013 RZR 570 LE. They are attached to the floor by driving screws through the plastic which is kindof lame.. They cover the screws for the center console, so you have to remove them to get the center console out, which is also kindof lame.. Next time I have to pull the center console I'm taking the plasma cutter to them and trimming them back so that I don't have to take them out again...Read All Reviews