Zander in AZ
This product works great. We have gone through 3 water pump seals from tusk that would fail after 1 hour of riding. This one has about 12 hours on it and it's doing fine. Hot rods includes the little tool to press the mechanical seal on and includes in depth instructions in the packaging. Instructions includes torque specs and all procedures.
Read All ReviewsCaleb in LA
The bearings fit well into my 2005 WF250F. No problems, no fitting required. So far, they seem to work fine.
Read All ReviewsMIKE in CA
Never had a problem with any of the hotrod crank assembly. I have worked in a shop for more than 20 years have personally installed close to 500 and never had a single problem with them
Read All Reviewsjesse in OH
Really good quality bearings for my 1990 Kawasaki kdx 200. Old bearing weren't bad but for the price I went ahead an wanted to replace them. Really nice bearings for the price. Going to buy them again for my other bikes.
Read All ReviewsEvan in SC
Great quality product, have not had any issues in 12 hours of ride time.
Read All ReviewsMelvin in KY
I’ve used these when I rebuilt my engine and had to go back in awhile later to replace them with OEM cause they caused my seal to go bad from the slack they got in them after they where used for awhile. They last for awhile but I don’t know I don’t think I would buy them again. I’d go with OEM even if they cost more. I wouldn’t buy them again.
Read All Reviews