MARK in CA
I think these are great! I ride mostly in a warm to hot open desert climate. I got the smaller ones. I needed them to replace the old ones that were damaged. Just screwed them on and was finished!
Read All ReviewsJames in KY
Ordered a polisport to begin with, straight out of the package it had a few small crease lines in it. So figured I would give this one a try and the quality seems to be a lot nicer then the polisport.
Read All ReviewsNoah in CA
Easy to install. The only option really if you have Cycra Probends and 1 1/8 Handlebars.
Read All ReviewsJohn in AZ
These things take a beating and saved several clutch levers. My only gripe is they make it very difficult to reach my fork bleeder screws (ProTaper bars). Readjusted fork tubes to barely access the screws. Other than that they're great and I'll buy again
Read All Reviewscary in CA
Fit is great and love the 3-bolt mounting. Easy to install and coverage of the motor an pump is great. I did trim the brake side because it did interfere with my boot. Not a big deal to me I modify everything?
Read All ReviewsAdam in OH
I have used Cycra handguards for years as they have been the strongest system. This is the first time I have used flex bars and was happy to see that Cycra had a set that was a direct installation. However as others stated they do not fit up correctly out of the bag. Lots of trips back and forth to my vise to get them to fit up. Does not make sense since they are specific for the flex bars and not a universal item. Also the hinge point on the flex bars are threaded but this kit does not have a bolt that threads into the hinge point they instead use a long bolt that goes though the hinge point and uses a plastic tube as a spacer to hold the guard out from the bars. Time will tell but I see that this will bend easy. I may get a larger bolt to thread directly into the flex bar hinge and fabricate a metal spacer. In the end this system is still probably better than the universal fit guards with an adaptor.
Read All Reviews