With the introduction of the new KTM 50SX clutch, comes a new innovative Factory Clutch cover. The new clutch is now fully adjustable by turning three clickers on the front of the clutch allowing the rider to fine tune the clutch feel with a wrench. No more dis-assembly and stacking shims to get the clutch right. With the new KTM Factory Clutch Cover you will be able to turn the clickers through a small port in the side of the cover. Unlike in stock form where the cover must be removed to make clutch adjustments the Factory cover can remain in place and the bike can even be sitting on a bike stand. The adjustment port is above the oil line so there is no need to drain the oil or lay the bike on its side. One 8mm socket or T wrench removes the billet plug and makes the clutch adjustments. The adjuster bolts are lined up with the port hole by first turning the back wheel to align the basket with the port hole then pushing the kick starter to line the bolt up with the basket hole. Next you simply make the clicker adjustment then push through the kicker to move the next bolt into the window. Complete on the fly adjustments can be done in just a few minutes. The cover holds 50cc more oil which will help with oil temps and uses the stock “O-ring gasket. This is a must have item, get the most out of the new adjustable clutch with the addition of the Factory Clutch Cover.