bought this to use for adjusting the air/fuel mixture on cv carbs, that i think it says it is made for but the shaft was too big to fit into the hole. on the bright side, it worked very well as part of my homemade valve adjusting tool for the kaw concours 1000
Nobody makes an aftermarket air/fuel screw for my bike. If you're in the same boat then this is a MUST HAVE. Nothing is worse than pulling your tank loosening your carb boots twisting your carb to get to the screw "eh, let's try half a turn" turn carb back around tighten boots tank back on seat back on... "STILL TOO LEAN!!" over and over and over and over again. Did I mention this is a must have?
Unless you have the fingers of a 4 year old, this tool is pretty much useless. It's not the tools fault, just there is not enough room to use the tool. Save your money and by an after market Fuel Mixture Screw.