Motion Pro Pilot Screw Adjusting Tool

Great tool for fine tuning fuel screws. Fixed bend and only strait screwdriver tip, so if you have a d style or other head on fuel and air screws, you'll need to buy a different style. All mine are the same, so for the price I couldn't go wrong with it.

The geared version fits into tighter spots than this one. This tool works fine on easier to access mixture adjustment screws but I have come across plenty of machines that this will not work on.

Great tool to adjust air fuel mixture screw that is located on the bottom of carb. Although the slotted screw part moves into the case. I had to grind away about 1/4 of an inch so I didn’t have to keep pushing the handle forward to use.

This tool is a great idea but made from soft low grade material. Bought it for my 07 RMZ450 and spent more time trying to get it to work than what it was worth. In the end, the cable inside twisted and snapped in less than one use. not recommended.

Wasn't sure what to expect when I ordered this but I was very impressed and use it quite often

This is a great tool and fit just fine using it on a 2001 XR100R. Only thing I didn't really care for is if you push up as if your holding it on the screw too hard, the blade of the screwdriver sinks into the tube and soon disappears. If your careful, this can be overcome by not pushing too hard.

Tried to use it to adjust carb on LTZ400. It did not work good on this carb.

Get one that is gear driven

Love this tool..what a time saver. Setting air screw is easy with this tool.

Pretty tool.....to bad it didnt work for me

its hard to tell if its turning the pilot because its not very smooth

Works ok, as long as you don't have the D shaped head.

On this tool, the screwdriver tip, is connected on flexible shaft, that also allows the screwdrivers tip, to move inward and outward a half inch or so. Around the screwdriver tip, is a stationary housing. The tool works much better, if you cut about 1/2" of this stationary housing off. It is not a very hard material, hack saw works well for that job.

I work on a lot of different bikes this tool comes in handy from time to time,not bad for the price.

Bought this to adjust the air screw on a Raptor. Doesn't fit it. I have used it on many other bikes since then though.

It works OK on the race bikes but it takes a little getting use to it

Seems like a good design and well made but the tip is just too long to fit between the bottom of the carb and top of the starter motor on any bike I tried it with (KTM, Suzuki, Kawasaki).