You are viewing a combination of machine-specific and universal parts. Please choose a machine to display parts specific to your machine or select a part below.
User Tip: If you're unsure of your vehicle type, you may skip the machine type selection box.
Stands and Lifts
John in CO
Which is worth the $$$ over a cheaper version. While this one is also made in China, it holds your heavy, expensive bike steady while in the air. Granted, if there’s not a flat surface to jack the bike up with the flat platform of this jack, a little creativity is required. On mine, one has to jack on the engine/trans. crankcase, which is a little convex (comes to a slight point in the middle, where the 2 halves bolt together), so I used a couple pieces of metal to make contact from the jack platform to the footboard brackets, which also bolt to the engine case (no frame rails under the engine at all). This worked well, & I’m satisfied. Also, Rocky Mtn. was the only retailer I found that sells this jack at less than MSRP. Thanks!Read All Reviews
Daniel in CA
After unboxing the stand and looking it over I quickly noticed The welds were messy and it had no rubber feet ,so it’s metal to ground .Due to the weld joint at the bottom metal H and because there’s no rubber feet the stand rocks back and forth on hard surfaces. I returned the Stand in the end ,to many other choices to try and make this stand work!Read All Reviews
Blake in MI
Quality was not good, usually I like tusk stuff and think the quality is good for the price which led me to trying this out but was not a fan of it. It did not sit flat on the ground and did not operate smoothly. Pay the extra money and pick up a nicer quality one with a larger platform as well.Read All Reviews