- MOUNTAIN TIME
- ¡Hablamos español!
Attack Graphics Seats & Covers
You are viewing a combination of machine-specific and universal parts. Please choose a machine to display parts specific to your machine or select a part below.
User Tip: If you're unsure of your vehicle type, you may skip the machine type selection box.
2022 CAN-AM Outlander 850
Delete this machine from profileSelect this machine
Latest Seats & Covers Reviews – You could win up to $500 for reviewing products!
Enduro Engineering Tall Seat
CHRIS in NY
Yep
Works good no complaint. Would recommend if looking for a budget option
Read All Reviews
Neutron Gripper Seat Cover
George in WA
Yeah! That looks right bro!
Didn't know if I was going to like it as much as i do right now but after I put it on, it looks far better than I had hoped! If your seat is all torn up and gangly, buy 1 of these, slip it on and change the look of your bike man!
Read All Reviews
KTM SXS Wave Seat
Annie in OR
Great seat
Great seat Im a trail rider and this seat keeps you stuck to it on steep hill climbs when you need to sit down . Showed up three days after ordering and fitment was exact as advertised.
Read All Reviews
Seat Concepts Complete Seat
Joe in ID
Worth the money!
Best upgrade I've bought for my bike so far. Highly recommend!
Read All Reviews
Attack Graphics Factory Seat Cover
Nick in CA
The Trick To Install Wrinkle Free
This seat is a bit difficult to install but can be done without wrinkles. The trick is (for me at least) was to push the cover down into the foam and then work the downward pressure outwards toward the sides and then staple. This makes it such that the foam pushes against the cover and removes wrinkles. I tried for the longest time to just pull the seat cover over the edge to get tension and remove wrinkles; this does not work My full steps were 1. mount the front part over the seat 2. pull longitudinally and staple the rear to add some tension in the seat length wise and to keep the seat cover parallel to the seat 3. work from front to back going alternating sides as you go towards the back of the seat 4. push down into the foam near the middle of the seat then keeping the downward pressure move your thumb towards the outside 5. With the foam and cover pressed down roll around the seat lip and staple the inside of the seat 6. do the same for the other side (start at step 4) 7. repeat step 4 again but move towards the back by about 2"
Read All Reviews
Enduro Engineering Low Seat
Kelli in NM
Not very soft and required extra tools
This seat did help with the height however it is stiff foam and doesnt have the comfort of other seats. It is better than the stock seat. There is a stock black plastic part that sits on the top edge of the seat and allows the bolt to go through that has to be moved from the stock seat to the new seat. There is a significant amount of foam on the new seat in this area and required special narrow tip vice grips to get the black plastic piece low enough into the seat in order to get the ring to seat on the bolt. It could not be done manually without the vice grips.
Read All Reviews
