Luxon Gen3 Rubber Isolated Handlebar Mounts Kawasaki Cone

Details

Luxon 4-post style bar mount is rubber isolated and designed to reduce vibration felt from the engine, eliminate twisting in small crashes and tip-overs, and absorb hard hits and track roughness without compromising steering precision. Three different rubber bushing hardness levels are included to fine tune the feel. Luxon mounts are lighter than stock, yet resist twisting up in crashes with the 4-post design.

These bar mounts fit Kawasaki motorcycles with triple clamps using a rubber cone interface (most all off-road and motocross bikes). They will work in both the forward and back triple clamp mount hole locations and have the same bar position geometry as stock (height and offset).

Three different hardness levels of rubber bushings are included at no additional cost. Soft (green) is for lighter riders, vet riders, or those with wrist injuries. Medium (yellow) is recommended for most off-road and motocross use, and hard (red) is recommended for aggressive motocross use and faster riders. It is also possible to mix different hardness levels of top and bottom bushings (for example, medium uppers with hard lowers) for further tuning.

Depending on the installation type, make and model of bike, bar mount position, etc., you may need to lightly trim plastic brackets and/or relocate hour meters or accessories to allow clearance for these bar mounts in some mount positions (typically not an issue on motocross bike installations).