To give our customers the best shopping experience, our website uses cookies.  Learn More

motorcycle Handlebars & Controls

You are viewing a combination of machine-specific and universal parts. Please choose a machine to display parts specific to your machine or select a part below.

Choose a machine

User Tip: If you're unsure of your vehicle type, you may skip the machine type selection box.

Use one of my Saved Machines

Latest Hand Controls Reviews – You could win up to $500 for reviewing products!

  • Tusk Clutch Lever

    Holly in AL

    Breaks easily. Rattles.

    Dropped the bike on the first run with this lever, not hard and in soft dirt. Lever broke. Didn’t even get to finish warming up. It also rattles from not fitting right. You get what you pay for.

    Read All Reviews
  • Motion Pro Brake Lever

    Chris in SC

    MP levers

    Good replacement lever. Fit is spot on and finish same as stock

    Read All Reviews
  • Motion Pro Clutch Cable

    Vicente in NV

    Shorter than OEM

    The quality is good, however it was a little short. There is no slack at all. based on other reviews, I'm expecting some stretch, so I will wait and see how it goes. This is a total rebuild of an 1999 RM 250.

    Read All Reviews
  • Tusk Brake Lever

    Steve in UT

    Good and priced right

    Inexpensive and fit well. I always have a couple on hand and keep one in my tool pack for trail side repairs.

    Read All Reviews
  • ProTaper Universal Rubber Mounted Handlebar Clamp Kit

    Nathan in MI

    Good Bar Mounts

    Good quality bar mounts - allowed me to mount Pro Taper 1 1/8 bars to my yz125 2006 clamps. The D bolt on these has a shoulder that is a little too long for the clamp - so I used a lock washer to fill the gap on each side.

    Read All Reviews
  • Magura Hydraulic HYMEC Clutch

    Spencer in UT

    CR250R a requirement if attempting trails

    2003 Honda CR250R after installing this the clutch was way easier to pull I could ride all day no problem on the honda it will significantly help arm pump The only reason for the four stars is because I had to install a little spacer that came with the magura clutch and it was not explained how to install that or even what that little spacer was for. basically the spacer is for when you have a brand new clutch. if you have a broken in or almost worn out clutch you don't need the spacer at least on the cr250r aka keep that spacer around if you replace clutch plates

    Read All Reviews
RM Cash ProgramParts Finder