After doing a few bearing changes on ours, I realize from the factory they are not even torqued correctly. Fits perfectly on the Raptors stock axle nut allowing me to torque it down good to seat the bearings. Add this to your order if you are going to replace axle bearings, right tool for the job.
When i ordered these I thought they were possibly aluminum but as it turns out they are made of good old fashion steel. I used my torque wrench with these and everything went great. Well worth the money.
Instead of tearing up your axle nut with a monkey wrench I would highly recommend this. Just put a breaker bar or any 1/2 inch ratchet into the slot and it breaks them free no problem saves a lot of time and hassle
Works well. Stop trying to use the wrong wrench and boogering it up. The rest of us can tell that you are trying to use a pipe wrench and it just makes you look bad. Use the right tool and get the job done right the first time.
They seem to be pretty good quality. Hopefully won't be used to often, but seem like they could handle daily use with ease. Fitment was good, must have 1/2" drive torque wrench or an adapter. They are 50mm crowsfeet wrenches. Made in Taiwan. Each wrench is packaged by itself.
Machine this part was bought for: 2003 YAMAHA RAPTOR 660
Bought these in a 2 pack, and glad there were 2. According to the Yamaha service manual the inner nut gets torqued to 40 foot pounds, the the outer nut to 140 fps then the inner backed off to 175 fps. The first wrench bent before hitting the 2nd 140 fp mark! The second one held up, but had to use a pipe wrench to hold the outer nut while doing the final 175 fp tourque. Good build quality, but they need a better and stronger alloy to hold up to this amount of stress. 3 to 4 stars.
Machine this part was bought for: 2002 YAMAHA RAPTOR 660
the tool was very use full to have to remove the rear axle after turning the jam nuts loose especially having the correct size tool to get the nuts lose with out stripping them I highly recommend this product !
Machine this part was bought for: 1999 YAMAHA WARRIOR 350
I really like these because they take up far less space in out traveling tool kit than having 2 big wrenches. We've had and axle nut come lose on one of our riding trips. Immediately after that I ordered these. Now we take them with us every time we go out in our tool kit.
Machine this part was bought for: 2006 HONDA TRX 450ER
THESE ARE WORTH IT, THEY ARE NARROW ENOUGH TO WORK UNLIKE MOST CRESENT WRENCHES AND WAY CHEAPER THAN BUYING 2 HUGE WRENCHES. VERY HEAVY DUTY, CAN KICK THEM AROUND THE SHOP FLOOR FOR MANY YEARS TO COME. MUST HAVE IF YOU MAINTAIN YOUR OWN ATV.