To give our customers the best shopping experience, our website uses cookies.  Learn More

dirt bike reeds

You are viewing a combination of machine-specific and universal parts. Please choose a machine to display parts specific to your machine or select a part below.

Choose a machine

User Tip: If you're unsure of your vehicle type, you may skip the machine type selection box.

Use one of my Saved Machines

Latest Fuel and Air Intake Systems Reviews – You could win up to $500 for reviewing products!

  • V-Force 3 Reed Valve

    Tony in CA

    V Force Reeds

    Power Improvement WOW!!! Easy to install. Immediate improvement

    Read All Reviews
  • JD Jetting Jet Kit

    Pasquale in VA

    Noticeable Improvement!

    After years of just dealing with and trying to jet around the dreaded lean bog that plagues the '06 CRF250R, I finally broke down and decided to give this kit a try. All I can say is WOW. Why didn't I buy this kit sooner? The instructions were pretty straight forward, and I installed the suggested needle, main jet, and set the recommended float height (found on their website). Just riding it around the yard, I noticed that it was noticeably easier to start, and it was MUCH more responsive off idle which translated into a much harder hitting feeling off the bottom. I haven't track tested it yet, but I was able to get the bike to bog while it was just on the stand. HOWEVER, I noticed that in order for it to bog, I had to snap the throttle much faster and harder than before. Once I take it to the track, I will be able to verify if the bog has been cured or not. It's not entirely uncommon for the bike to bog on the stand like that, so I'm still hopeful. Also--the kit does address the lean bog issue and includes O-Rings for the AP timing screw. Only complaint I have with this kit is for the money, it should have included some pilot jets. So make sure you have a couple clean pilot jets with you if you order kit PN JDH002. This is why I gave this a 4-star review.

    Read All Reviews
  • Tusk Fuel Mixture Screw

    Paul in OH

    Make your carb great again.

    Carbureted four strokes need this upgrade. Adjust lean rich mixture by hand while it's running. Pipe red hot? Richen it up by turning this screw out a half turn at a time. Sooty exhaust? Lean it out by turning screw in a bit.

    Read All Reviews
  • R & D Racing Flex Jet (Remote Fuel Screw)

    Keith in GA

    Difficult to count turns.

    Not a fan of this. Can never tell when it?s screwed in all the way or not. Have torn two of the tiny o-rings. I would have switched to the longer, solid screw if I had not sold the bike. Could have been user error, most people like these. Was on a CRF150rb

    Read All Reviews
  • Dynojet Jet Kit

    Cory in TX

    XR650L DYNOJET KIT

    Installation was very straight forward, bike runs very well and has more power. Acceleration is much better now.

    Read All Reviews
  • Pro X 99101-357 Series Keihin Hex Main Jet

    ERNIE in CA

    Pro X 99101-357 Series Keihin Hex Main Jet

    Although not a Keihin factory jet it is of good quality. The jet size is stamped onto the bottom (as it sits in the carb) and it pretty small for this old man to read!! I installed and it fits fine and seems to be milled to the correct size.

    Read All Reviews
RM Cash ProgramParts Finder