You are viewing a combination of machine-specific and universal parts. Please choose a machine to display parts specific to your machine or select a part below.
User Tip: If you're unsure of your vehicle type, you may skip the machine type selection box.
Fuel and Air Intake Systems
Skyler in AZ
Upon receiving this kit i noticed that none of the jets were manufactured as the OEM jets. Even the “stock” sized jet was noticeably bigger, it also required an adapter to fit into the bowl. I decided not to use this kit and bought all OE jets. 2000 Honda 400ex with bolt ons.Read All Reviews
Jeff in IL
You will need to transfer parts from an OEM PW80 Carb to make this work. 1. The metal tube that the choke cable goes into on the carb does not work a PW80. You will need to buy it or have one to transfer. 2. There is a white plastic spacer that sits inside on the intake side of the carb and it is to thick and will not fit the pw80. You will have to reuse the oem or modify it. Also, the idle adjustment screw must be wrapped in Teflon to keep the screw from backing out under vibration when the bike is running. I will say it does work once you make these modifications and it is jetted properly for my pw80 but for an extra $60 I would have just bought the OEM Carb. Remember, there is a reason why it cost less than a quart of 2T OilRead All Reviews
Raymond in OR
Replaced this screw on my keihin carb. Fit fine and is SOOOO much easier to adjust while on the trail than the stock screw. Only minor complaint is that I'm fairly sure it is a little too loose and vibrates slowly out of place. Could just be my retaining spring though. Otherwise awesome replacement. Would do it over again.Read All Reviews