For as simple as a part that this is, it took some work to figure out how it was supposed to be installed. No instructions are included. You'll need remove the lower shock bolt AND the rear dog bone bolt. Otherwise its almost impossible to fish the small half into place. It uses a simple thread forming screw to hold the two halfs together.
-m-2020 HUSQVARNA TE 300i (Fuel Injected)--
The fit was tight around the shock bolt. I had to use a mallet to tap it into place.
No instructions come with this protector so follow my advice and lift the rear end of the bike, remove the lower shock to linkage bolt, slide the protector over and in place, then replace the lower shock to linkage bolt.