You are viewing a combination of machine-specific and universal parts. Please choose a machine to display parts specific to your machine or select a part below.
User Tip: If you're unsure of your vehicle type, you may skip the machine type selection box.
JENNY in TX
This works and was easy to wire up, but it doesn't fit that great on the bars for where I need to put it, and is rather thick/takes up space, so it can limit the adjustability of your clutch lever position in/out on the bars. I had to do it to make my bike street legal, but it's not my favorite.
Read All ReviewsJoe in CO
Quality is decent on these Tusk LED turns, stock turn was sitting on top of my FMF exhaust so i decided to replace with these shorter stalk LEDs. If you are installing on a XR650L, you will need a EP34 led compatible flasher relay, factory connector plugs right in, then run a ground leg from relay into headlight harness grounds. If you want the dash turn indicator to work splice in two 1N4001 rectifier diodes to the indicator (org/blue) wiring otherwise pull the stock turn indicator bulb for easy way out-otherwise new signals will all flash at once.
Read All ReviewsDennis in MT
Just what I wanted easy to install and works great.
Read All ReviewsAnonymous in IN
Small flush mount turn signals just like I wanted the work great for my dualsport
Read All ReviewsPaul in IA
Excellent fit after you figure out how to run it, I added protective covering everywhere there where wires without the protective coating. Works as it should
Read All ReviewsTucker in NV
Let me start this off by saying I haven't rode with it on yet, but I think it will do well and my expectations of the product are high and I think it will hold up well. The battery is nice, the light bar is really nice( I got the 12inch), the charger is nice, and the harness is pretty good. I didn't notice much weight added to the bars and looks pretty nice. The handguards I went with are Acerbis X-Factory. Here are my honest complaints on the product. The mounting brackets are cheap trash, but are pretty difficult to get into a spot I like, and they HAVE to mount handguard mounts. This adds another $50-$80 you have to spend to make this product work correctly. My other thing is the light switch, it is fine and will get the job done, but for the price I would expect something a little nicer. Overall, though I would still recommend to a friend. The bike it's on is a 2009 CRF450R.
Read All Reviews