You are viewing a combination of machine-specific and universal parts. Please choose a machine to display parts specific to your machine or select a part below.
User Tip: If you're unsure of your vehicle type, you may skip the machine type selection box.
Fuel and Air Intake Systems
Cautious in NV
Great instructions and easy to install. I did remove the carburetor on my 2005 Drz400s for this installation (unbolting and leaning back the rear sub-frame eased removal and installation). 2005 Drz 400s 3x3 air box mod and Yoshimura RS-3 slip on.Read All Reviews
Nick in CA
I bought this carburetor for a cheap replacement for my kids dirt bike $18 isn't a whole lot but the amount of time I have in this trying to figure out a problem is ridiculous the slide doesn't slide all the way down and return to idle due to the bore is too small and not circular for the slide to return so it holds the throttle at about 1/3 a throttle open the needle and seat assembly flooded over right out of the box I bought Rocky Mountain parts for years this by far is the first thing I've ever bought that was a complete waste of money yes it was only $18 I'm going to buy the OEM one for a hundred you cannot replace the seat or the needle this is a Chinese piece of junk it's not Rocky Mountains fault except they chose a very poor piece of aftermarket parts I'm not your normal Joe Schmo who knows how to work on stuff I'm a mechanic for a living I've taken Japanese Mikuni parts to try to make this thing run I got it to run but it still flooded over the needle and seat is garbage it's been a week of screwing around with this thing I would never buy it again stick with OEM I bought this for a PW50 I advise whoever buys it next spin a little bit more money for one that works this carburetor is trashRead All Reviews
ARTHUR in ON
this kit combine with new jets and needle its amazing love it,just buy itRead All Reviews